Quick Setup; Connection Diagram; Speaker Stand Installation - ION Total PA Supreme Guia Del Usuario

Quick Setup

Connection Diagram

Items not listed under
Introduction > Box
Contents are sold
separately.
Microphones
Tablet

Speaker Stand Installation

1. Fully extend the speaker stand tripod legs on a flat, stable
surface. Look in the box contents under the foam sheet for the
rubber feet and speaker stand mounting knob.
2. Raise the mounting pole up to the appropriate height needed
and tighten the side adjustment knob.
3. Insert the pin into the bottom pin-hole so the mounting pole
stays at your set height.
4. On Total PA Supreme, adjust the bottom knob counter-
clockwise so the screw is not blocking the opening.
5. Line up the Total PA Supreme mounting hole with the speaker
stand pole and place on the pole.
6. Tighten the mounting knob clockwise on Total PA Supreme.
3
4
CHARGE
USB drive
4
SD Card
Smartphone
Power
1
2
5/6