Maintanance Of Blades Housing : Fig; Technical Data - Beper 40.451 Manual De Instrucciones

EN
Split end hair trimmer Use instructions
HAIR PREPARATION : FIG.5
Before use the hair trimmer it is suggested :
Wash the hair to remove any oils and product solution that maybe on it (spray, gels...)
DO NOT use styling products.
If you have curly or freeze hair it is recommended to straight them before use the hair trimmer.
Dry the hair
Comb completely the hair and remove any possible tangle.
Divide the hair in the middle in two half section. Clip away one half section from the back toward the front using
one of the two clips provided, as shown on the image, to keep it out of the way while treating the other side.
Repeat it on the opposite side after finish treating the first half section.
WARNING: THE HAIR TRIMMER WILL ONLY WORK IN CLEAN AND FULLY DRY HAIR.
USE: FIG. 6
Take a small, "thin" section of hair, comb it to remove any tangles
Open the plate using the appropriate button (6)
Select the arrow pointing to the floor and press the button. The item can be used with right as well as with the
left hand, just remember to activate the direction with the selector (the arrow will always be facing downwards)
A green light indicate that the product is in operation and ready to use
Take the small selection of hair and place it on the top of the hair plate, in correspondence of the central guide.
The section of hair should not be thicker than the height of the central guide and no wider than the width of the
central guides.
Gently squeeze the pressing handle (4) and the product will start working
Hold with one hand the upper part of the section of hair and the trimmer with the other hand.
Proceed with slow movement from above downwards, such as with a brush
Treat every section of hair three times.
If you feel that is pulling the hair then you either have too much hair on the hair plate, or the hair is not free of
tangles. Take some hair out brush it and try again.
While you are treating the hair, you will see the hair chamber getting full of little bits of hairs, so stop for a minute
and empty it.
IT IS SUGGESTED TO REPEAT THE TREATMENT EVERY 5-6 WEEKS.
CLEANING: FIG. 7
Release the plate using the appropriate button
Hold the handle with one hand while with the other gently pull the transparent window outwards
Empty the container by inverting the plate
To remove any residue, especially near the blades, use the brush provided
After you have finished install the clear window back to the housing
Never use water or other liquids for cleaning

MAINTANANCE OF BLADES HOUSING : FIG.8

Release the plate using the appropriate button
Remove the transparent window
Hold the handle with one hand while with the other gently pull the blade housing outwards
Once removed the blades section apply a single drop of clipper oil to each side of blades
Assemble the blade housing again
Switch on the item for few second
Now the item is ready again

TECHNICAL DATA:

Power:110-240V-3W
Rechargeable Lithium Battery, 2000 mAh
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
11