Publicidad
Idiomas disponibles
Idiomas disponibles
When work has been
completed, both the
spray gun must be
cleaned
with
the
appropriate thinner, in
order to remove any
remaining product.
In order to carry out maintenance, repairs
or cleaning, first disconnect the unit from
the compressed air distribution network.
We recommend using this unit in premises
with forced ventilation and in accordance with
the current standards and provisions on the
matter.
Near the unit, only keep the amount of product
and thinner required for the work being done
at that time. After work has been completed,
thinners and the product to be applied must
be returned to their corresponding storage
location.
Keep the working area clean and free of
potentially dangerous waste (thinners, rags,
etc...).
While work is in progress, there must not be
any source of ignition (naked flames, lighted
cigarettes, etc.) in the working area as these
might generate easily flammable gases.
Likewise, the approved protective means must
be used (breathing, hearing, etc.) in
accordance with the regulations established
in this regard.
If the unit is used in an inadequate manner or
its components are altered in any way severe
material damage may occur and bodily harm
may be caused to the operator, other personnel
and/or animals and may even cause death.
SAGOLA S.A. accepts no responsibility in for
any damage caused through the incorrect use
of the unit.
Never exceed the maximum air inlet pressure
(10 bar). Excessive pressure will cause greater
environmental contamination. To control the
air pressure of the hose, fit a pressure regulator
to the air inlet of the sealing gun.
10. CLEANING
Remove any remains of product from the gun
with a cloth soaked in thinner.
Never use halogenous hydrocarbons.
Keep air gasket areas free of accretions and
foreign bodies.
11. HEALTH AND SAFETY
As a general, preventive measure we advise
you to wear goggles in accordance with the
specific environmental regulations and
characteristics for the work centre.
The gun in itself does not propitiate any
mechanical risk of perforations, impact or
pinching, except those deriving from incorrect
installations and handling.
While work is in progress, no vibrations are
transmitted from the gun to any part of the
body of the operator and reaction forces are
minimal.
USE SAGOLA ANTISTATIC HOSES TO
ELIMINATE
DISCHARGES THAT MIGHT CREATE THE
RISK OF FIRE OR EXPLOSION.
Pay adequate attention when handling the gun
in order to prevent any damage that might lead
to dangerous situations for the user or
personnel standing near the unit, as a
consequence of leaks, breakages, etc. Do not
use it if your mental capacity, perceptions and
reactions are altered due to substances such
as alcohol, drugs, medicines, etc., or by
tiredness or for any other reason.
The gun has been designed for use at ambient
temperature. Its maximum service temperature
is 50°C. Although the air temperature of the
compressed air or product is higher, this must
not exceed the maximum average temperature
in the body of the gun. If the temperature
excedes 43°C, it is necessary to use personal
protective equipment, such as gloves to
thermally insulate your hands from the unit.
The use of solvents and/or detergents that
contain
(trichloroethane, methyl chloride, etc.), may
- 19 -
POSSIBLE
ELECTRICAL
halogenated
hydrocarbons
Publicidad
Capítulos
