Publicidad
Idiomas disponibles
Idiomas disponibles
ALUMINUM MODELS ONLY:
A. Using a tape measure double check the height of the ceiling.
B. Determine the location to cut the ladder rail and ladder feet for your ceiling height. Follow
table 3 and Figure 12.
CEILING HEIGHT
7' 8" - 7' 9"
7' 10" - 7' 11"
8' - 8' 3"
8' 4" - 8' 5"
8' 6' - 8' 7"
8' 8" - 9' 2"
9' 3" - 9' 4"
9' 5" - 9' 10"
9' 11" - 10' 3"
C. Cut the side rails and ladder feet (when required) at the appropriate line.
NOTE: The rail is not pre–marked for angle cuts.
D. Press down on the climbing section to ensure that the folding arms are fully extended.
8
RAIL CUT LOCATION
Angle cut at step #3
Straight cut at line C
Straight cut at line C
Straight cut at line C
Angle cut at step #2
Straight cut at line B
Straight cut at line A
Angle cut at step #1
No cut
TABLE 3
FIGURE 12
FOOT CUT LOCATION
Line E
Line E
Line D
No cut
No cut
No cut
No cut
No cut
No cut
Publicidad
