Fulgor Milano FCHD 900 RC X Instrucciones Para La Instalación Y Uso página 15

INSTALLATION
Take the product out of the packaging and place
it on a suitable surface: we Suggest to use a soft
material, such as a sponge or a cloth.
Open the glass panel , rotating it as shown in Fig.
1, and remove the grease filters.
IN CASE THE HOOD COMES WITH A GLASS
PANEL BEFORE INSTALLATION , IN ORDER
TO AVOID
ANY POSSIBLE DAMAGE TO THE GLASSES,
WE RECOMMEND TO REMOVE THEM BY
UNSCREWING THE EIGHT SCREWS SHOWN
IN FIG. 2.
Where you intend to install the appliance, you
must create a recess which will have a rectangu-
lar opening of:
865x515 mm model SLT971 Cm.90
1165X615 mm model SLT971 Cm.120
The depth must range from 200 to 280mm.
INSTALL THE HOOD ON THE CEILING, CON-
NECT THE CANAL SYSTEM FOR THE AIR
OUTLET, SET
THE ELECTRICAL CONNEC! TION AND THEN
COMPLETE THE PLASTERBOARD STRUCTU-
RE.
The recess shall be provided with a socket and a
round pipe of 150mm diameter, or a similar sec-
tion, for the air outlet.
Drill the holes on the ceiling , as shown in Fig. 3.
Insert the plastic plugs into the holes made, and
then fix the ceiling brackets as shown in Fig. 4.
The ceiling brackets are telescopic, so their
height can be adjusted at 80 mm between the
ceiling and the hood.
You can choose one of the three air outlets shown
in Fig. 5: fit the air outlet plastic flange in the de!
sired outlet; the remaining outlets shall be closed
with the specific metal caps , as shown in fig. 5.
Bring the hood close to the brackets previously fi-
xed and then connect the appliance to the supply
mains.
Secure the hood to the ceiling, by using the
screws supplied, as shown in Fig. 6.
15