Beta 1550U Instrucciones página 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• Check the connections and the air supply lines. All units, couplers and hoses should conform to the
product specifications in terms of pressure and air volume. Too low pressure impairs the function of the
machine; too high pressure can cause damage and/or injury.
• Do not bend or tighten any hoses; avoid using solvents and sharp edges. Keep the hoses away from
heat, oil and rotating parts. Immediately replace any damaged hose. A defective feed pipe may cause
uncontrolled movements of the machine. Make sure that the hose clamps are always secured firmly.
PERSONNEL SAFETY
• Stay alert; watch what you are doing. Do not use the shock absorber removal tool while tired or under the
influence of drugs, alcohol, or medication.
• When installing or removing any shock absorbers, check the position of your hands, to avoid crushing
them.
• The shock absorber removal tool can only be operated when the protective "FULL BODY" grid
is completely closed.
Always use the following personal protective equipment:
• Safety shoes;
• Eye protection;
• Protective gloves against physical agents.
• Make sure you are in a safe position, keeping proper balance at all times. A safe working position
and a proper body posture enable better control in unexpected situations.
• Do not wear loose clothing or jewellery. Keep your hair and clothing away from moving parts.
Loose clothing, jewellery, and long hair can get caught in moving parts.
SHOCK ABSORBER REMOVAL TOOL USE AND CARE
• Do not overload the shock absorber removal tool; always check that it is free from defects.
• Make sure that the spring is correctly held in the bracket, to prevent it from being suddenly pulled out.
• Do not allow persons unfamiliar with these instructions to operate the shock absorber removal tool.
• Do not modify the shock absorber removal tool. This can reduce or nullify the effectiveness of safety
measures and increase operator risk.
• Maintain the shock absorber removal tool with care. Check for misalignment or binding of moving
parts, breakage or damage of parts or any other condition that may affect the operation of the tool.
• Have the shock absorber removal tool repaired only through a trained repair person and only using
original replacement parts.
• Every 200 operating cycles or approximately every 3 months, remove dirt and dust from the sliding
parts (column) with a dry cloth.
SHOCK ABSORBER REMOVAL TOOL SAFETY
• Make sure that the brackets have been correctly placed and fixed, depending on the spring to remove.
• Periodically perform a complete check of the shock absorber removal tool, making sure that
all the parts are intact and perfectly efficient.
• Turn off the machine in case of air supply failure or low operating pressure. Check the operating
pressure; turn on the machine again when optimal operating pressure is resumed.
8
EN I