Loading The Tool - Bostitch N88RH-2MCN Manual De Operación Y De Mantenimiento

LOADING THE N88
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply
is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
N88RH-2MCN
1. Open the magazine:
Pull pusher back to
engage the latch.
NOTE: Use only nails recommended for use in Bostitch N88RH and N88RH-2MCN nailers or nails which
meet the Bostitch specifications.
When installing metal connectors with the N88RH-2MCN: Use only one stick of metal
connector nails at a time.
3
2. Load Nails:
Hold nailer down with
magazine tilted downward.
Insert stick of nails
3. Close Magazine:
Release pusher by first pulling back on
the pusher and then pressing the pusher
release tab. Slide pusher against nails.
6
2