Loading The Tool - Bostitch IC60-1 Manual De Operación Y Mantenimiento

LOADING THE IC60-1
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the
air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
1. Open the canister: pull down down latch and swing door open. Swing canister cover open.
2. Check adjustment: the nailer must be set for the length of nail to be used. Nails will not feed
smoothly if the magazine is not correctly adjusted. The IC60-1 accepts from 1" to 2-3/8" nails.
To change setting:
a) Release the canister latch on the rear of the canister. Door
Canister Canister
b) Pull out canister bottom by swinging right to left until tabs disengage. bracket bracket
Canister Canister
c) Inside the canister bracket are settings in inches and millimeters. The canister is adjusted
bottom bottom
correctly when the length of the nail being used is shown in the window of the canister bottom.
.
IN MM
1 3/4
(45)
2 (50)
2 1/4
(57)
2 1/2 (65)
2 3/4
(70)
3 (75)
3 1/4 (83)
Window
NOTE: Use only nails recommended by BOSTITCH for use in BOSTITCH IC60 Series nailers or nails
which meet BOSTITCH specifications.
All manuals and user guides at all-guides.com
Canister Canister
cover cover
Canister Canister
latch latch
Door
Feed pawl Feed pawl
3. Load the coil of nails:
Place a coil of nails over the post in the canister. Uncoil
enough nails to reach the feed pawl, and place the second
nail between the teeth on the feed pawl.
Canister
The nail heads fit in slot on nose.
bracket
4. Swing cover closed.
5. Close the door.
Check that latch engages. (If it does not engage, check that
Canister
the nail heads are in the slot on the nose).
bottom
Note: The canister is adjusted correctly for 1-1/2" nails when
"1-3/4 (45)" appears in the window of the canister bottom.
-6-
Door Door
Canister Canister
bracket bracket
Feed pawl
Canister Canister
bottom bottom
Canister Canister
cover cover
Canister Canister
latch latch
Feed pawl