Loading The Tool - Bostitch MARK III Manual De Operación Y De Mantenimiento

LOADING THE MIII
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
STAPLE AND NAIL LOADING:
Pull cover open. Insert stick of staples or nails. Push cover
forward until the detent pin snaps into place, locking the cover.
The tool is now ready to operate.
WHEN USING 3/4" AND SHORTER T-NAILS:
When using 3/4" (19mm) and shorter T-Nails the following components need to be changed out:
Item #31 (BC711F) needs to be changed with 105044
Item #40 (BC1016) needs to be changed with BC1360
Item #41 (BC392) needs to be changed with BC1357
All above replacement components are supplied with the tool.
* Driver damage may occur without proper conversion of above parts.
NOTE: Use only fasteners recommended for use in Bostitch MIII series models.
-6-