Publicidad
Idiomas disponibles
Idiomas disponibles
6. The display shows CRANKING, the battery's voltage and a blinking key icon.
7. Start the engine. The display will show the minimum voltage reach by the
battery and provide an assessment of starting system condition. Assessment
corresponds as follows:
OK – Starting System OK.
LO – Starting System Weak
---- – Starting System Problem. Check connections, wiring and starter
immediately.
8. After Starting System Test, press ENTER to go to Charging System Test.
Display will show ALT.
9. Run the engine to 1200 – 1500 rpm. The tester will display the charging system
voltage without loads and provide an assessment of that reading. Assessment
corresponds as follows:
OK – Charging System OK
HI – Charging Voltage is High
LO – Charging Voltage is Low
10. Next, the tester can provide an assessment of the charging system under load.
11. Without pressing ENTER, turn on the following accessories: blower to high
(heat), high beam headlights, and rear defroster.
Note: Do not use cycling loads such as air conditioning or windshield wipers.
12. The tester will display the charging system voltage under loads and provide an
assessment of that reading. Assessment correspond as follows:
OK – Charging System OK
HI – Charging Voltage is High
LO – Charging Voltage is Low
13. Press ENTER to perform an assessment of alternator ripple.
14. The tester will display the detected alternator ripple and provide an assessment
of that reading:
OK – Normal Ripple Detected
HI – Excess Ripple Detected
Publicidad
