Accessories; Troubleshooting - Petsafe Deluxe PCF-1000-20 Manual De Funcionamiento

Accessories

To purchase additional accessories for your PetSafe
our website at www.petsafe.net to locate a retailer near you.
Component
Replacement Battery - Receiver Collar
Power Adapter for the Fence Transmitter
Replacement Collar
Additional Receiver Collar
Additional Boundary Wire
Additional Boundary Flags
Wire & Flag Accessory Kit
Additional Gel-Filled Capsules and Wire Nuts
Fence Transmitter
Accessory Pack (Extra Contact Points, washers,
batteries, battery lid, and Waterproof Seal)
Receiver Collar is not beeping or
correcting.
The Receiver Collar is beeping, but
my cat is not responding to the Static
Correction.
The Receiver Collar has to be held on
top of the Boundary Wire to activate.
The Receiver Collar activates inside
the house.
I have an inconsistent signal.
18
®
In-Ground Cat Fence

Troubleshooting

• Check battery to make sure it is installed properly.
• Check that both lights are lit on the Fence Transmitter. If not, perform
the "Short Loop
• Make sure that Static Correction Level is at 2 or above.
• Test the Receiver Collar with the Test Light walking toward the
Boundary wire.
• If the Test Light fl ashes, check the fi t of the Receiver Collar.
• Trim your cat's fur where the Contact Points touch the neck and/or switch
to the longer Contact Points.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
• Replace battery.
• Adjust Boundary Width Control knob clockwise to increase the distance
from the Boundary Wire that the Receiver Collar activates. You can also
adjust the Boundary Control Switch to another setting.
• If using a Double Loop, make sure Boundary Wires are separated 1 to 1.5 m
(3 to 5 ft).
• If the Receiver Collar still has to be held on top of the Boundary Wire,
perform the "Short Loop Test."
• Turn the Boundary Width Control knob counterclockwise to decrease the
distance from the Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running too close to the house. The
signal can transmit through the walls of your house.
• Make sure Boundary Wires are twisted from Boundary to the
Fence Transmitter.
• Make sure Fence Transmitter is at least 1 m (3 ft) from large metal objects
or appliances.
• Make sure all Boundary Wire turns are gradual.
• Make sure the Boundary Wire is not running parallel to and within 1.5 m
(5 ft) of electrical wires, neighboring containment systems, telephone wires,
television or antenna cables, or satellite dishes.
www.petsafe.net
™
, contact the Customer Care Centre or visit
Part Number
RFA-188
RFA-392
RFA-254
PCF-275-19
RFA-1
RFA-2
PRFA-500
RFA-366
RFA-385
RFA-39
Test."