Environmental Protection - Ryobi CPL-180 Manual De Utilización

EN
FR DE ES IT
MAINTENANCE
WARNING
Alignment of blade was preset. Adjustment
on the blade is not allowed.
REPLACING THE BELT (Fig.14 & 15)
When replacing the belt, use the recommended
replacement belt only.
Remove battery pack from tool.
Remove belt cover screws.
Remove the belt cover.
Force the old belt from the small pulley by turning in
the direction shown. As you turn the belt, pull and
work it off the small pulley until it has been completely
removed from both pulleys.
Install the new belt over the large pulley. As you turn
the belt, push and work it onto the small pulley until it
is in place.
Replace the belt cover.
Install belt cover screws and tighten securely, but do
not overtighten.
NOTE: Do not overtighten the screws.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
961067224-02(CPL-180 EU manual).indd Sec1:5
NL PT DA SV FI NO
English
RU PL CS HU RO LV
SYMBOL
Safety alert
No-load speed
CE conformity
EurAsian Conformity Mark
Read operator's manual
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
5
LT ET HR SL SK EL
12/29/09 4:17:27 PM
TR