Environmental Protection - Ryobi CPL-180M Manual De Utilización

página de 142

/ 142
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

MAINTENANCE

NOTE: Before removing the old blades, take notice of

the direction of cut as well as how the tapered edge of

the old blades are oriented. The tapered edge of the

new blades must be in the same orientation as the

original blades.

Push the blade (to the right) out of the blade holder

using the tip of a screwdriver.

Remove the old blade from the blade holder.

NOTE:If the blade can not be easily pushed out of

blade holder after loosening blade securing screws,

use a block of wood to break the blade loose from

the blade holder, with a short sharp blow. Then push

the blade with a screwdriver to remove. If necessary,

tap the block of wood sharply with a small hammer to

break the blade loose.

Clean any sawdust or wood chips from around the

blade area.

Slide the new blade into the slot of the blade holder.

Use a screwdriver to push the blade into the blade

holder until it is centered into position.

Retighten the two blade securing screws using the

blade wrench.

Repeat the above procedure to change the other

blade.

Clamping screws must be tighten strongly

WARNING

Alignment of blade was preset. Adjustment on

the blade is not allowed.

FIN

English

REPLACING THE BELT (Fig.14 & 15)

When replacing the belt, use the recommended

replacement belt only.

Remove battery pack from tool.

Remove belt cover screws.

Remove the belt cover.

Force the old belt from the small pulley by turning

in the direction shown. As you turn the belt, pull and

work it off the small pulley until it has been completely

removed from both pulleys.

Install the new belt over the large pulley. As you turn

the belt, push and work it onto the small pulley until it

is in place.

Replace the belt cover.

Install belt cover screws and tighten securely, but do

not overtighten.

NOTE: Do not overtighten the screws.