Fox LIVE VALVE Guia De Inicio Rapido página 5

4. Install a zip tie around the center of the
sensor clip.
5. Install a cable clip near the head tube on the
front sensor cable and the other cable.
Do not install any zip ties anywhere between this
cable clip and the sensor clip. The front sensor
cable is equipped with a quick release to prevent
cable damage in the event of a crash. This quick
release will not function if the sensor cable is zip
tied anywhere between this cable clip and the
sensor clip.
6. Remove the fork air cap. Use a hex wrench
to release all of the air from the air valve.
Compress the fork to bottom out and make
sure the strain relief loop in the cable allows
the cable to move freely as the fork goes
through its travel.
NOTICE
5