Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7 Troubleshooting
Programme cannot be started or selected.
•
Washing machine has switched to self protection mode due to a supply problem (line voltage,
water pressure, etc.). >>> To cancel the programme, turn the Programme Selection knob
to select another programme. Previous programme will be cancelled. (See "Canceling the
programme")
Water in the machine.
•
Some water might have remained in the product due to the quality control processes in the
production. >>> This is not a failure; water is not harmful to the machine.
Machine vibrates or makes noise.
•
Machine might be standing unbalanced. >>> Adjust the feet to level the machine.
•
A hard substance might have entered into the pump filter. >>> Clean the pump filter.
•
Transportation safety bolts are not removed. >>> Remove the transportation safety bolts.
•
Laundry quantity in the machine might be too little. >>> Add more laundry to the machine.
•
Machine might be overloaded with laundry. >>> Take out some of the laundry from the machine
or distribute the load by hand to balance it homogenously in the machine.
•
Machine might be leaning on a rigid item. >>> Make sure that the machine is not leaning on
anything.
Machine stopped shortly after the programme started.
•
Machine might have stopped temporarily due to low voltage. >>> It will resume running when the
voltage restores to the normal level.
Programme time does not countdown. (On models with display)
•
Timer may stop during water intake. >>> Timer indicator will not countdown until the machine
takes in adequate amount of water. The machine will wait until there is sufficient amount of water
to avoid poor washing results due to lack of water. Timer indicator will resume countdown after
this.
•
Timer may stop during heating step. >>> Timer indicator will not countdown until the machine
reaches the selected temperature.
•
Timer may stop during spinning step. >>> Automatic unbalanced load detection system might
be activated due to the unbalanced distribution of the laundry in the drum.
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
C
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
Foam is overflowing from the detergent drawer.
•
Too much detergent is used. >>> Mix 1 tablespoonful softener and ½ l water and pour into the
main wash compartment of the detergent drawer.
Put detergent into the machine suitable for the programmes and maximum loads indicated in
C
the "Programme and consumption table". When you use additional chemicals (stain removers,
bleachs and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme
•
Excessive foam might have occurred and automatic foam absorption system might have been
activated due to too much detergent usage. >>> Use recommended amount of detergent.
Machine does not switch to spinning step when the laundry is not evenly distributed in the drum
C
to prevent any damage to the machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
If you cannot eliminate the problem although you follow the instructions in this section, consult your
A
dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
17
EN
2820522485_EN/240312.0901
Publicidad
Tabla de contenido
