Adjusting The Infrared Beam; Still Image Recording - Celestron NV-2 Manual De Instrucciones

ADJUSTING THE INFRARED BEAM

• In the observing (still image/video recording) mode, hold
the Mode Button (8) for 3 seconds to enter the infrared
beam adjustment menu (as shown on the right). The digits
behind the "Lamp" show the current brightness of the
infrared beam.
• Press Mode Button (8) to select the "Lamp" to adjust the
brightness.
• Press the +/- buttons (6 & 7) to adjust the screen bright-
ness from 0 to 9. 9. To close the infrared beam, adjust the
brightness to 0.
• Once the infrared beam is on, "NL" will be indicated on
the upper left corner. The number behind the "NL" is the
current brightness setting of the infrared beam.
IMPORTANT:
The screen brightness adjustment menu and infrared beam
brightness adjusting menu will be automatically exited if
there are no operations made in 5 seconds after activating
the menu.

STILL IMAGE RECORDING

When you turn the device on, it is automatically in observing
(image recording) mode.
What the icons mean:
1. Photo mode
2. Battery life
3. Memory card is installed
4. The number of pictures that can be recorded based on
the memory capacity
Click the Enter Button (9) once to record one image. The
image will be saved automatically on the memory card.
The number displayed on the screen (4) indicates the total
number of images that can be recorded based on the card
memory capacity. This number is determined by the memory
capacity of the card. The actual number of pictures may vary.
8 I
ENGLISH
1 2 3 4