Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION: Read your manual carefully since it
contains instructions which will ensure safe
installation,
use
appliance.
Your freezer is built to International safety standards
(2006/95/CE). It also meets the standards on the
prevention and elimination of radio interference
(2004/108/CE).
- The manufacturer reserves the right to modify the
characteristics of the models without prior notice.
- Some models may not have all the accessories
indicated.
Warning:
This appliance must be earthed.
A plug with a bared flexible cord is hazardous if
engaged in a live socket.
1. This appliance is designed to be used indoors and
under no circumstances should it be installed
outside, even if protected by a roof. Leaving the
appliance exposed to the rain and whether is
exceedingly dangerous.
2. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
3. Do not attempt to operate or handle this appliance
when barefoot, or with wet hands or feet.
4. It is highly recommended that you do not operate
this appliance by connecting it to the power supply
with extensions or multiple socket plugs. If the
freezer has been installed between two cabinets,
make sure that the supply cord is not dangerously
crimped or trapped beneath a heavy object.
5. Never pull the cable or the appliance to remove
the plug from the socket.
6. Do not touch the internal cooling elements,
especially if your hands are wet, since you could
burn or hurt yourself. Do not place ice cubes straight
from the freezer into your mouth as this may result in
burns.
7. Before doing any cleaning, disconnect the
appliance from the electricity (by pulling out the plug
or turning off the general switch in your home).
8. Before disposing of your old appliance, remember
to break or remove the lock as a safety measure to
protect children who might lock themselves inside the
appliance when playing. In addition, if the appliance
is a new one with a lock, keep the key out of the
reach of small children.
9. If your appliance is not operating properly, read
the chapter entitled, "Troubleshooting", which might
help you resolve the problem. Do not attempt to
4
and
maintenance
Safety
repair the appliance by tampering with the internal
components.
of
your
10. If the power supply cord must be replaced,
please note that in some cases, the connections are
made using special terminals and in others a special
tool must be used to access the connections. This
operation should only be performed by an authorized
agent.
11. Do not use electric appliances inside the
compartment for food storage, if these are not those
recommended by the manufacturer.
12. Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
13. Do not store explosive substances such as
aerosol cans with a flammable propellant in this
appliance.
14. At the end of the functional life of your appliance -
containing cyclopentane gas in the insulation foam
and
perhaps
refrigeration circuit - it should be made safe before
being sent to the dump. For this operation, please
contact your dealer or the Local Organisation in
charge of waste disposal.
15. Do not damage the refrigeration circuit.
16. Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clean and clear
of obstruction.
17. The maximum load per shelf is 40 kg.
Fuse replacement
If the mains lead of this appliance is fitted with a BS
1363A 13 amp fused plug, to change a fuse in this
type of plug use an A.S.T.A. approved fuse to BS
1362 type and proceed as follows:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important: The fuse cover must be refitted when
changing a fuse and if the fuse cover is lost the plug
must not be used until a correct replacement is fitted.
Correct replacement is identified by the colour insert
or the colour embossed in words on the base of the
plug. Replacement fuse covers are available from
your local electrical store.
Connection to a rewireable plug
If the fitted plug is not suitable for your socket outlet,
then it should be cut off and disposed of in order to
avoid a possible shock hazard should it be inserted
into a 13A socket elsewhere. A suitable alternative
plug should then be fitted to the cable. The wires in
this mains lead are coloured in accordance with the
following code:
BLUE - neutral ("N")
BROWN - live ("L")
R600a
gas
(isobutane)
EN
in
the
Publicidad
Tabla de contenido
