Setting Up The Appliance - Eurofred KITCF 350 PROW BT Manual De Instrucciones

GREEN AND YELLOW - earth ("E")
1. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is marked
with the letter "E" or by the Earth symbol or coloured
green or green and yellow.
2. The BLUE wire must be connected to the terminal
To ensure that the appliance operates properly and to
reduce energy consumption, it is important that the
appliance is installed correctly.
Ventilation
The compressor and condenser generate heat and, therefore,
need to be ventilated properly. Rooms with no ventilation are not
suited for installation of the appliance. Therefore, it should be
installed in a room with an opening (window or French window)
that provide the appropriate amount of air re-circulation. It is also
important to install it in a free humidity room.
During installation, make sure not to cover or obstruct the grates
that allow for proper ventilation of the appliance. For proper
ventilation of the appliance, leave a space of at least 10 cm
between the sides of the appliance and any adjacent
cabinets/walls.
Away from Heat
Avoid positioning the appliance in a place where it is directly
exposed to sunlight or near an oven, cook top or the like.
A - Temperature Adjustment Knob
Turning the knob will adjust the temperature inside the appliance.
B - Thermometer
C – Shelves (maximum load: 40 kg per unit)
D - Fan System
Before starting the appliance, follow the installation instructions
(see "Installation").
Before connecting the appliance, clean the compartments and
accessories with lukewarm water and bicarbonate.
Insert the plug into the socket.
Adjust the temperature knob "A" to the required temperature
setting.
Using the freezer to its full potential
Remember that you should never refreeze products you have
allowed to thaw, even if only partially. Once thawed, cook the
food, then either eat (within 24 hours) or refreeze it.
For the best storage and thawing, remember to freeze small
portions. This will ensure rapid and uniform freezing.
Mark package with a description of the contents and the date it
was frozen.
Never freeze more food than that allowed by the maximum
freezing capacity indicated on the data plate which is located
inside the appliance.
Place the food to be frozen into the freezer, making sure that it is
placed, to the furthest extent possible, in direct contact with the
side walls of the deepest part of the freezer and not in contact
with food that has already been frozen.
Avoid opening the freezer door during the freezing process.
Installation
The Appliance

Setting Up The Appliance

Efficient Usage of The Appliance
which is marked with the letter "N" or coloured black.
3. The BROWN wire must be connected to the
terminal which is marked with the letter "L" or
coloured BROWN or RED which is connected to the
fuse.
Electrical and Earth Connection
The appliance should not be turned on right after transportation.
Two hours is the advised time so that the oil from the motor-
compressor gets back to its original position.
Before proceeding with the electrical connection, make sure that
the voltage indicated on the rating plate, located inside the
appliance, corresponds to the mains voltage in your home and
that the socket is fitted with a standard earth wire in accordance
with safety standards. If the socket is not fitted with an earth wire,
the manufacturer will not be held liability for any damages and or
injuries arising out of the use of the appliance. Do not use
multiple sockets or adapters.
Position the appliance in such a way that you can access the
socket where it is plugged in.
Insufficient power
The electrical socket must be able to handle the maximum power
load of the appliance, which is indicated on the rating plate
located inside the appliance.
The Fan System stops operating while the door is open.
E - Regulation feet
F - Defrost water discharge hole
G – Fan System Switch
At this point the freezer can be used.
NOTICE
Use average temperature settings to ensure optimum
performance and to save energy.
Some models may not have all the functions described.
In the case of power failure or breakdown, do not open the
freezer door. This will help maintain the temperature inside the
freezer, ensuring that the goods are conserved for at least 12
hours.
Do not place full bottles in the freezer because liquids increase in
volume when they freeze and this could cause the bottles to
burst.
Follow the instructions on the packages of frozen foods
scrupulously. If none are provided, do not store the food for more
than 3 months from the date of purchase.
When purchasing frozen food, make sure that they have been
stored at the proper temperature and that the package is properly
sealed. If the package is damp on the outside or is abnormally
swollen, it is likely that the package was stored at an inadequate
temperature and the food has deteriorated. It is best to transport
them in appropriate containers to keep them cold and then place
them in the freezer immediately.
5