BOMANN TSG 7404 Instrucciones De Servicio página 64

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Control lamp: lights up, when the water supply
is closed.
6 The control lamps indicate the program selection.
7 The control lamps indicate the start delay selec-
tion. 6h is indicated by 2h and 4h simultaneously.
Starting a program
 The water supply must be opened to maximum
pressure.
 Load the dishwasher basket.
 Fill in the detergent.
 Turn on the appliance.
 Set the required program options.
 Start the operation.
Changing the program
CAUTION:
A program change should be done only a short time
after starting the program. Otherwise, maybe deter-
gent has been dissolved and rinse water drained off.
First press the Start/Pause button to stop the
current rinse program.
 Press the Program selection button for about
3 seconds.
 Select a new program and start the new opera-
tion.
Forgot to add a dish?
WARNING:
Open the door very carefully during operation, there
is a risk of water squirting out.
Dishware can be added any time before detergent
has been dissolved or rinse water drained off.
 Press the Start/Pause button to stop the opera-
tion. Once the spray arms have stopped, you can
fully open the appliance door.
 Add forgotten dishware.
 Press the Start/Pause button, the operation will
continue after approx. 10 seconds.
At the end of program
CAUTION:
Allow the appliance to cool down a bit after the pro-
gram has ended, before you open it. This avoids that
steam escapes that causing long-term damages to
your furniture.
At the end of the rinse cycle will sound a series of
signals; then the unit goes into standby mode.
If no operation takes place within 15 minutes, the
device switches off automatically - energy-saving!
Turn off
 Turn off the appliance.
 Close the water supply, if necessary!
 Remove the dishes after cooling (see "Unloading
the dishwasher").
 Leave the appliance door slightly open until the
next rinse cycle to avoid odors.
 If the appliance is not in use for an extended peri-
od, disconnect it from the power supply!
Unloading the dishwasher
CAUTION:
Let the dishware cool down for about 15 minutes
before unloading. Hot dishes are sensitive to knocks.
NOTE:
At the end of program there could be still water drops
inside the appliance.
Open the appliance door and pull out the basket.
64

Publicidad

Tabla de contenido
loading

Tabla de contenido