Honeywell CO60PM Manual Del Usuario página 16

CLEANING & MAINTENANCE
DRAINING AND CLEANING THE WATER TANK
Turn the power off and disconnect the air cooler from the power supply.
•
Move the unit to a location where it can be drained.
•
Remove the drain plug and allow the tank to empty(#12 on Page 8).
•
Refill the water tank up to the maximum level with clean water and drain
•
it completely.
Fill water tank and rinse at least 2-3 times before use.
•
After cleaning ensure that the drain plug is back in place.
•
• Plug into the power supply and turn on unit.
CLEANING THE HONEYCOMB COOLING MEDIA
• Turn off the unit, and unplug the power cord from wall
outlet.
•
Rotate the unit facing the back panel, and locate the Rear
Grill Removal Screws (#15 on Page 8). Remove the 4
screws with a screw driver.
•
Pull the rear grill panel, until it is completely
•
This cooler has Honeycomb cooling media on the right and
left panels. The cleaning and removal procedure is the same
as rear panel.
•
The Honeycomb cooling media can now be seen. Clean
honeycomb with clean cloth to remove all the dust &
dirt particles.
•
Once cleaning is finished, reassemble the unit.
•
Plug into the power supply and turn on unit.
14
removed.
Water Drain
Plug
Open Screws