DJI Ronin-SC Manual De Instrucciones página 9

Calibration
The focus motor can be used before calibration, but the range
that the focus wheel can rotate the motor will be limited. After
calibration, the focus wheel will be able to fully rotate the motor.
Calibrate Procedure
1. For lenses with a mechanical limit, calibration can be done
automatically. Press the focus wheel multifunction button
twice to calibrate the focus motor.
Focus Wheel
Multifunction Button
2. For lenses without a mechanical limit, calibration must be
done manually. Press the focus wheel multifunction button
twice to start the calibration.
a. When the motor rotates to the start point, stop the motor
manually. The motor will continue to rotate and stop the
motor manually again when it reaches the start point.
b. Repeat the step above to confirm the end point.
Set Focus Motor Range
The range of the focus motor can be set by confirming Points
A and B on the focus wheel.
Rotate the motor to the desired Point A and press the focus
wheel multifunction button to confirm. After Point A is confirmed,
repeat the step to confirm Point B. Press the focus wheel
multifunction button again to delete Points A and B.
Press and hold the focus wheel multifunction button to reverse
the rotational direction of the focus motor.
EN
7