Clatronic AR 815 USB/CR Manual De Instrucciones página 70

Installation in ISO Slot
D
C
B
A
C
‹
Remove sleeve (D) and frame (B) from the unit. Use installa-
tion keys (C), if necessary.
‹
Place the sleeve in the ISO slot.
‹
Bend the claws outward with a screwdriver for perfect fit.
‹
Check the sleeve for tight fit.
‹
Connect the ISO female connectors of the unit with the two
ISO male connectors of the vehicle.
‹
Connect the antenna to the antenna connector at the rear of
the unit.
‹
Secure the unit against theft, if necessary. Attach bolt and
mounting strip with the fastening materials at the firewall.
70
All manuals and user guides at all-guides.com
‹
‹
‹
CAUTION
Cable damage possible!
►
‹
Remove Unit
Follow these instructions to remove the unit:
‹
‹
‹
►
Toyota or Nissan Installation
►
Carefully slide the unit into the sleeve until it locks into place.
RESET (4) with a pen or other pointed object after all
Press
connections are made.
Attach the front panel (A) as described under "Attach Front
Panel".
To avoid ca ble damage observe the cables when sliding the
unit into the sleeve.
Attach the frame.
Remove the frame.
Insert left and right installation keys in the slots left and right
(the claws are now bent back).
Slide the unit out of the sleeve.
NOTE
Unevenness of the casing can cause the claws to lock.
Unlock the claws with the installation keys, if necessary.
NOTE
Sleeve, frame and mounting strip are not needed.