Troubleshooting - Clatronic AR 815 USB/CR Manual De Instrucciones

Problem Possible cause
Unit cannot be turned on. The car ignition switch is not on.
The volume is set to minimum.
No sound
Wiring is improper.
Presence of disc inside the player.
Disc inserted in reverse direction.
The disc is extremely dirty or defective.
Disc cannot be loaded or is
CD format is not supported.
ejected.
Mistake with home-burnt CD.
Temperature inside the car is too high.
Condensation on the laser.
Installation angle over 30
CD skips.
CD dirty or damaged.
The built-in microcomputer is not operating
properly due to noise.
The operation keys do not
work.
The front panel is not correctly installed.
The antenna cable is not connected
The radio does not work or no
auto scan.
The signals are too weak.
Station memory does not Terminal 4 of ISO connector A (continuous posi-
work. tive) not properly connected.
The USB port is only for proper USB devices.
Not all available devices comply with the
USB device does not work.
standards. Possibly a non-standard device is
connected.
SD/MMC memory card does
The unit cannot read the card.
not work.
All manuals and user guides at all-guides.com

Troubleshooting

.
o
Solution
If the power supply is properly connected to the car ac-
cessory terminal, switch the ignition key to "ACC".
Increase the volume.
Check the wiring.
Remove the disc in the player, and then load a new one.
Insert the compact disc with the label facing up.
Clean the disc or try to play a new one.
Insert a different CD.
Check your CD in a different player.
Cool off or wait until the ambient temperature returns
to normal.
Turn the unit off for several hours until the moisture is
evaporated.
Decrease installation angle to less than 30
Clean the CD or play different CD.
Press RESET (4).
Remove the front panel, press RESET button and install
again.
Insert the antenna cable firmly.
Select a station manually.
Check the cabling. Observe chapter "Connections".
Connect a USB-conform device. Ensure the media is
formatted in FAT32 format.
Check the card. Insert with the label to the right. Ensure
the media is formatted in FAT32 format.
.
o
77