bora UUE 1 Manual De Instrucciones Y Montaje página 13

Mounting Instructions / Maintenance / Replacement
4. Push the connection fitting with sealing tape onto the outflow opening of the base fan or onto a
preinstalled exhaust duct of the Naber System "Compair Flow 150 oval".
5. Now remove the protective film from the attached Velcro
fastening on the underside of the rear housing shell.
Attach this to an adjacent component (e.g. floor, kitchen
cupboard, etc.) to ensure that the recirculation unit is
secured in position.
6. Start the cooktop extractor unit and check the sealing on the connection fitting.
Replacement of the Recirculation Unit:
1. We recommend that you exchange the recirculation unit at an interval of about 12 months. The useful life
of the filter components is highly dependent on the frequency of use of the unit.
2. In this respect, open the access panel (e.g. base opening, the back wall of the cabinet frame) to replace
the recirculation unit.
3. In the event that the recirculation unit housing is attached to an adjacent component (e.g. with adhesive
tape) loosen it prior to removal. Now pull the unit connection fittings from the duct piece / base fan.
4. Proceed to reattach the new recirculation unit in the same way (see Chapter with the Mounting
Instructions) to the air duct.
5. The old recirculation unit can be properly disposed of in the domestic waste.
GB
13