Before Use; 5-1.Standard Equipment; 5-2.Optional Accessories; 5-3.Safety Measures - Temper KOBAN KEV-01 Instrucciones De Operación

5.Before Use

5-1.Standard Equipment

The following equipment and accessories are included in the package, before using the unit,make sure that all
items are included.
• Main Unit x 1
• Type 2 Test Cable x 1
• Portable Package x 1
• Instruction Manual x 1 (This document)

5-2.Optional Accessories

Type 1 Test Cable for EV charging station cable type 1 with fixed cable and vehicle connector which fits to all
versions of the test adapter.

5-3.Safety Measures

• The test adapter has been built and tested in compliance with the valid safety regulations and left the factory in
safe and perfect condition.
• In order to maintain this condition and to ensure safe instrument operation , the user must pay attention to the
references and warnings contained within this user manual.
WARNING, DANGER OF ELECTRICAL SHOCK
• In order to avoid electrical shock, valid safety and national regulations regarding excessive contact voltages must
receive utmost attention when working with voltages exceeding 120V DC or 50V RMS AC.
• The respective accident prevention regulations established by the national health & safety board for electrical
systems and equipment must be strictly met at all times.
• Prior to any operation, ensure that the adapter and cable assemblies are in perfect condition.
• The adapter may only be connected to charging stations as indicated in the technical specification section.
• The adapter may only be used within the operating ranges as specified in the technical specification section.
• The adapter may only be used in dry and clean environments, dirt and humidity reduce insulation resistance and
may lead to electrical shocks, particularly for high voltages.
• Never use the adapter in precipitation (e.g., dew or rain), in case of condensation due to temperature jumps, the
adapter may not be used.
• Perfect tests and measurements may only be ensured within the temperature range of 0 to 40°C.
• If the operator's safety is no longer guaranteed, remove the adapter from service and protect against use.
• To ensure a safe measurement only use original cable assemblies.
• If the operator's safety is no longer guaranteed, remove the adapter from service and protect against use.
• Safety can no longer be guaranteed if the adapter (or cable assemblies):
Show obvious damage.
Do not carry out the desired tests or measurements.
Have been stored for too long under unfavorable conditions.
Have been subjected to mechanical stress during transport.
Test Adapter for Electric Vehicle Charging Stations
7