Worx WX175 Manual Original página 16

LED LIGHT INDICATOR (See Fig. G)
Before operation, the LED light will be activated when the
On/Off switch is slightly depressed, and will automatically
turn off 20 seconds after the On/Off switch is released.
WARNING: To turn on the light, press the On/Off
switch and make sure the Forward/Reverse
Rotation Control is on right/left position.
The tool and battery are equipped with a protection
system. When the LED Light is quickly flashing 60
seconds and turn off, the system will automatically cut
off power to the tool to extend battery life. The tool will
automatically stop during operation if the tool and/or
battery are placed under one of the following conditions:
• Overloaded: The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, release the Trigger Switch on the tool and
stop the application that caused the tool to become
overloaded. Then pull the Trigger Switch again to restart.
16
• Overheated: Under the condition above, if the tool does
not start, the Tool and Battery are overheated. In this
situation, let the Tool and Battery cool before pulling the
Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is
too low and the tool will not operate. In this situation,
remove and recharge the Battery.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward and Reverse Switch, which is on top of the
trigger, is positioned in the lock function. Unlock the
Forward and Reverse Switch putting it into the required
rotation position. Push the trigger and the drill will start
to rotate (See Fig. B).
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the Torque Adjustment
Ring, you can find the Torque Adjustment Ring between
the Chuck and the drill body. Position 1 is the lowest
torque (screw driving force) and position 22 is the
highest torque (screw driving force). Position
drill operation. Position
Regulate the Torque Adjustment Ring to a higher
position to reach the best result (See Fig. E).
3. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED Light should turn on when the
battery is charging.
4. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not
used a Battery Pack for a prolonged time will reduce the
Battery Pack working time. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such
as large screws into hard wood will use up the Battery
Pack energy faster than lighter working conditions. Do
not re-charge your Battery Pack below 0°C and above
45°C as this will affect performance.
MAINTENANCE
Remove the Battery Pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
is for
is for hammer drill operation.