Before Starting The Equipment - Robust RB-PO 110 Manual De Instrucciones Original

Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
6. Operation
6.1 Mounting the polishing bonnet on the po-
lishing disk (Fig. 2)
1. Turn the car polishing machine upside down
so that the polishing disk is facing up.
2. Pull the textile polishing bonnet over the poli-
shing disk (Fig. 2). Make sure that the textile
polishing bonnet is free of any foreign bodies.
6.2 Applying wax/polishing paste to the texti-
le polishing bonnet (Fig. 3)
Note: Use only high-quality waxing and polishing
products and follow the processing instructions
issued by the manufacturer on the packaging.
Distribute the polishing agent evenly as far as the
edge of the textile polishing bonnet so that a uni-
form, thin coating is produced overall.
Note: Applying too much polishing agent will only
make it more diffi cult to remove the layer of poli-
shing agent later from the paintwork and will not
improve the results.
6.3 Switching on and applying the polishing
agent to the paintwork
Note: The paintwork you want to process must be
carefully cleaned and completely dry. Severely
oxidized paintwork requires the use of a special
Anl_RB_PO_110.indb 15 Anl_RB_PO_110.indb 15
GB
cleaner.
Select a cleaner from the products available to
suit the state of the paintwork and the stress it is
exposed to.
1. Dab with the textile polishing bonnet on dif-
ferent positions of the paintwork you want to
polish. This will help to distribute any excess
polishing agent over the textile polishing
bonnet and/or over the paintwork you want to
polish.
2. Hold the handle of the equipment fi rmly in
both hands, place the polishing machine onto
the paintwork you want to polish (Fig. 4) and
switch on the equipment by pressing the On/
Off switch (Fig. 1 / Item 3).
3. First work on the large level surfaces such
as the engine hood, boot lid and roof (Fig.
5), then on the smaller surfaces such as the
doors and mudguards (Fig. 6). Guide the
equipment smoothly over the paintwork, exer-
ting no pressure.
4. Switch off the equipment with the On/Off
switch (Fig. 1 / Item 3) before you remove it
from the paintwork you are polishing.
5. For areas which are diffi cult to reach, remove
the textile polishing bonnet from the polishing
disk and process these areas by hand (Fig.
7).
6.4 Polishing the paintwork with the synthetic
polishing bonnet
Note: After the previously applied polishing agent
has dried completely on the paintwork, you can
begin with the polishing. Damp polish will be sme-
ared by the synthetic polishing bonnet.
1. Replace the textile polishing bonnet with the
synthetic polishing bonnet. Make sure that
the synthetic polishing bonnet is free of any
foreign bodies.
2. Remove the polish layer in the same order in
which you applied the polishing agent to the
paintwork. Be sure to follow the instructions
issued for using the waxing and polishing
agent.
- 15 -
29.07.14 08:59 29.07.14 08:59