Residual Risks; Installation Conditions - Fast & Fluid Management Hercules Manual Del Usuario

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
Residual risks list for the user
1.
Even if all attentions have been considered during the projecting of the machine to guarantee a safety use it is possible to find
situations rationally foreseeable for which it has been possible only to reduce the risk but not to eliminate it completely
RISK
Injuries or crushing during loading and unloading
operations
Abrasions and injuries caused by sharp edges and
parts of the cans to use
Liquid leakages from the cans
2. Residual risks for technicians
RISK
Danger of electrocution during the setting phases
of the inverter
3. Personal protection for user
If the equipment is used in a correct way , the machine following the production conditions , do not present
risks or dangers for the operator , which in any case has to wear individual protection devices
( security glasses , security against sliding shoes, protective gloves ) specially during the loading and unloading
phases of the cans.
4. General danger situations
There aren't any particular danger situations ( E.G.. Fire risk, issue/ dispersion of dangerous products) but in any case it is
necessary to have a powder extinguisher for possible fire situations. (electrical equipments).
Security components and devices
The machine is equipped with the following security devices:
• An emergency push button
• A blocking door device
-> Emergency push button
For safety reasons, all users should know the position and the way to use the red emergency push button.
RED
The emergency push button is assembled on the operator panel on the right part of the front panel. Pressing this button
causes the immediate opening of the keeping tension circuit and the stopping of the rotation motor. The starting of the normal
functioning of the equipment is possible by rotating the emergency push button clockwise and when the diagnostic signal on
the display disappears. In case of emergency stopping during the working cycle it is necessary execute the resetting procedures
STOP KEY
by pushing .
-> Opening door sensor
The machine is equipped with a security device which doesn't permit the starting of the cycle if the door is in loading position.
During the working cycle the security device doesn't permit the opening of the door.
Before installation please make sure of the following:
Place the Digital Hercules on a firm and leveled floor
• 220-240 VOLTAGE: Provide a clean, grounded outlet of 220 / 240 Volt (or otherwise specified following local situations),
which has a differential (MINIMUM 30mA), a magneto-thermic protection of 16 Amp.
•
115 VOLTAGE: Provide a clean, grounded outlet of 115 Volt (or otherwise specified following local situations), which has
a differential (MINIMUM 30mA), a magneto-thermic protection of 25 Amp. and a ground net following the rules.
Environmental conditions are within the following limits:
Ambient air temperature
Relative humidity
During the installation it is advisable to use protective gloves to avoid hand injuries
7. RESIDUAL RISK
DIRECTIVE 392
1.6.4
4.1.1
1.6.4
4.1.1
DIRECTIVE 392
1.5.1
1.5.2

8. INSTALLATION CONDITIONS

: 10 to 40 °C
: 30 to 90 %
1155383H-it,en,es,fr,de - 12/06/2008
PRECAUTION
Use security protective gloves and shoes during
loading and unloading
operations
Use protective gloves during loading and unloading
operations
Clean carefully the area where the operator works.
PRECAUTION
Use security shoes.
Position protective screen for the dangerous
terminal blocks
.
15