Dab+ Operation - Lenco SCD-720 Manual De Usuario

Adjusting the Antenna
The antenna at the rear panel of the unit should be fully extended to ensure a good DAB+ / FM reception. Alter the antenna
position for the best reception.

DAB+ OPERATION

The first time the DAB+ mode is selected, it will automatically scan for available DAB+ stations. Wait until the scanning has
finished. The display will show the scanning progress. After scanning it will tune to the first station.
The available stations in a certain reception band will be shown in the display. In case of weak reception, the station
may falter or give no sound. Try to move the receiver or rotate the antenna so that the weak DAB+ signal comes in
without faltering (station names are still shown when the signal is weak).
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press and hold the SCAN button (or press the SCAN button on the remote control) to start auto scanning the available
stations.
Manual Scan
By using the manual scan operation, it can help you to adjust the antenna or search station that is missed while auto scanning.
1. Turn on the unit in DAB+ mode.
2. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
3. Press the button until "Manual" is displayed and then press the ENTER button.
or
4. Press the button to select the desired channel (e.g. 12C 227.360MHz) (Selection between 5A and 13F).
or
5. Press the ENTER button to confirm.
6. To select another channel (5A~13F), press the
7. When the station is found, press the ENTER button to select.
8. To quit manual scan, press the MENU button.
Tuning
After scanning all the available DAB stations, press the
the ENTER button to tune to this station within a few seconds.
Storing DAB+ Presets
You can save up to 20 DAB+ stations.
To use the unit buttons to store the preset:
1. Tune to the station you wish to store.
2. To save it to the preset 1 or 2 or 3, press and hold the numeric button respectively. Then it will save to that preset number.
3. To save it to other preset channel from 4 to 20, press and hold the numeric button "4". "Store" will be displayed.
4. Press the
or button to select the desired preset number to store.
5. Press the ENTER to store.
To use the remote control button to store the preset:
1. Tune to the station you wish to store.
2. Press and hold the MEMORY button, "Store" will be displayed.
3. Press the
or button to select the desired preset number to store.
4. Press the ENTER to store.
Recall Stored DAB+ Presets
To use the unit buttons to recall the preset:
1. To recall the preset channel 1 or 2 or 3, press the numeric button respectively. Then it will tune to that preset channel.
2. To recall other preset channel from 4 to 20, press the numeric button "4". "Recall" will be displayed.
3. Press the
or button to select the desired preset number to recall.
4. Press the ENTER to recall.
To use the remote control button to recall the preset:
1. Press the MEMORY button, "Recall" will be displayed.
2. Press the
or button to select the desired preset number to recall.
3. Press the ENTER to recall.
DAB+ RADIO
button and then press the ENTER button to confirm.
or
button to display and navigate the station list. Then press
or
-10-
REPEAT RANDOM
VOL
DISPLAY
REPEAT RANDOM
VOL
DISPLAY