Publicidad
Idiomas disponibles
Idiomas disponibles
16
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide
improved vibration resistance, reduced maintenance and
faster installation.
To connect wires, firmly insert a slotted screwdriver into
the square hole (
) to open the spring. When fully inserted,
1
2
the screwdriver will lock into place, allowing you to remove
your hand and insert the wire into the round hole (
Remove the screwdriver to clamp the wire. The wire is held
securely against the bus bar for low contact resistance
over time without the need to periodically retighten screws.
• Push screwdriver FIRMLY
into square hole.
THERMAL MANAGEMENT SOLUTIONS
).
1
2
• Insert wire into round hole.
• Use green terminal for
braid and ground wire.
EN-RaychemJBS100A100A6-IM-H56046.pdf 03/13
1
2
Wire
Screwdriver slot
Wire hole
• Remove screwdriver.
• Repeat for all connections.
7 / 8
Publicidad
