Vanderbilt Eventys EX4 Guia De Inicio Rapido página 11

Steps (for other models):
1. Remove the cover from the NVR by unfastening the screws on the rear and side panel.
2. Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
3. Connect the power cable to the HDD.
4. Place the HDD on the bottom of the device and then fasten the screws on the bottom to fix the HDD.
5. Re-install the cover of the NVR and fasten screws.
© Vanderbilt 2016
Remove the Cover
Figure 2.5
Connect the data cable
Figure 2.6
Connect the power cable
Figure 2.7
Place the HDD on the bottom
Figure 2.8
11