Sinmag Europe AUTOBUN Manual De Instrucciones página 21

CONTROL PANEL.
ENG
Pressing timer
Disable divison
E
button
CHAMBER HEIGHT
The position of the pin determines how far the dividing disc will rise, this way the space of
the rounding chambers is set.
Approximate chamber height setting depending on dough
G
Adjustment pin for chamber height.
G
Higher dough weight = higher value = larger rounding chambers.
PROGRAMING
Program number - From 1 to 10
Push button. Choose program number by using the
P
Pressing time - From 1 to 20 sec
Set pressing time by using the
The indicated time is in decimal seconds.
Rounding time - From 0.1 to 20 sec
Set rounding time by using the
The indicated time is in decimal seconds.
Saving program
After setting pressing and Rounding time, wait for a few seconds.
The display will blink and the values will be saved in the indicated program number.
6
Rounding timer
Emergency Stop
Start buttons
3-52 3-30
16g 25g
25g 45g
45g 80g
+ and - buttons.
+ and - buttons.
Program number
F
button
4-30 4-14 CHAMBER HEIGTH
40g 130g
70g 180g
120g 250g
and buttons.
+ -
Disable rounding
1,5
4
7