Configuration Menu (Installer); Access To Configuration Menu; Type Of Temperature Adjustment Mode - Perry 1TPTE011B Manual Del Usuario

11 - CONFIGURATION MENU (installer)

11.1 - ACCESS TO CONFIGURATION MENU

ATTENTION: access to the configuration
menu is recommended for the installer or
experienced users since the modification of
some settings might affect correct system
operation.
From normal thermostat operation, access the menus by
pressing for 5 secs. the « Mode » key.
If only an installer password was entered the
display requests entering the 4 digits, which may
be selected using the
confirm them with «OK».
Access the 1st item in the menu Set rEG SET
See this and other possible settings in the paragraphs below.
Using the keys scrolls through the
to the previous item. Settings in the menus must be confirmed by pressing the
the thermostat goes back to normal stand-by operation and changes will not be saved.
11. - TYPE TEMPERATURE ADJUSTMENT 2
METHODS
The thermostat is factory set to work in
ON/OFF with a preset thermal differential value (Hysteresis) of 0,3 °C.
Note: adjustable from 0,2 °C to 1,2 °C (from 0,3 °F to 2,1 °F).
The hysteresis value must be set according to the system's thermal
inertia; a low value is recommended for systems with radiators made of
( e.g. cast iron and a high value for systems with fan coils. )
; keys; individually
«Type of temperature adjustment».
Set PrOG menu items (see paragraph 8), press
THERMAL DIFFERENTIAL mode
/OK
OK
to enter the selected menu, press
OK
key where required, otherwise, after 60 seconds have elapsed,
thermal inertia over temperature of the heating element
°C/°F
T SET
hysteresis OFF OFF
ON
example of differential adjustment
/OK
or
1° 2°
Mode
to go back
ON
time
EN
37