Mounting The Trunnion-Mount Sounder; Figure 2 Side View Of Trunnion Mount; Figure 3 Bracket Dimensions - Federal Signal Global G-SND Manual De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Mounting the Trunnion-Mount Sounder

For the sounder dimensions, see Figures 2 below and Figure 4 on
page 10. Mount the trunnion bracket to a flat surface using the two
7.0 mm mounting holes (Figure 3). Use installer-supplied fasteners
suitable for the surface to which the device will be mounted.
To adjust the vertical angle of the sounder, loosen the fasteners on
the mounting bracket to disengage the ratchet. Vertically aim the
sounder, and tighten the fasteners.

Figure 2 Side view of trunnion mount

190.6 mm (7.50 in)

Figure 3 Bracket dimensions

60.0 mm 2X M6 SCREW HOLE
(2.36 in)
31.8 mm
(1.25 in)
Model G-SND Global Series Sounder
9