6
Maintenance
General Maintenance
The following is to be checked after each use:
●
Visual check of all parts for mechanical, chemical or heat-
related damage.
●
Visual check of the components for loose and/or missing
screws, as well as loose and/or missing O-rings and/or
seals.
●
For accumulators see instructions for use of the camera /
video transmitter
Note:
Components that do not pass visual inspection must be taken
out of operation until the appropriate repairs have been carried
out. Repairs or changes that are outside the measures
described in these instructions or in the instructions for use of
the camera / video transmitter or that are carried out by anyone
other than a person authorised by MSA AUER will invalidate any
warranty claim. Use only original MSA AUER replacement parts.
7
Cleaning
After each use all external surfaces are to be wiped with a solution
of a mild cleaning agent and warm water.
Then rub dry with a soft, dust- and lint-free cloth, during which
care is to be taken that optical components are not scratched.
Check connections, sockets, switches, locks and hinges for
fouling and if necessary clean with a soft, dust- and lint-free
cloth.
16
8
Technical data
8.1
Transmitter
(transmitter on/in the camera)
Adjustable frequency range: 2.3 - 2,5 GHz
Country-specific frequencies are pre-set. No setting of other
frequencies by the user is permitted.
Transmission power EIRP:
8.2Base station
Case:
W x H x D
Total weight in case
Power supply
Operation by mains voltage
Voltage range
Power input
Operation via motor vehicle on-board electrical system
Voltage range
Switch off for low voltage
Current input at 12V
Current input at 24V
Protection class
Operating temperature
Storage temperature
Antenna and Receiver
Antenna
Receiver
Adjustable frequency range: 2.3 - 2,5 GHz
Country-specific frequencies are pre-set. No setting of other
frequencies by the user is permitted.
Connecting cable
Video output for external monitor
BNC-socket
GB
450 mW
61,5 x 25 x 51,5 cm
17.0 kg
case closed
IP 66
AC 100 - 240 V,
50 - 60 Hz
approx. 30W
DC 11.7V - 30V
< 11.7V
1.8A
(with Clipmaker 2.2A)
1.1A
(with Clipmaker 1.3A)
II
0°C to 50°C
-10°C to 60°C
Directional antenna 18 dB
Aperture angle 16°
IP 65
7 m cable with DIN-AV plug for
adapter box
1V ss / 75Ohm / Pal
GB