Settings Adjustment - KS BAIONA Serie Manual De Instalación Y Funcionamiento

SETTINgS aDjuSTMENT

DETECTION
RANgE
DELAY IN TIME
SECuRITY TIME
COMFORT FLuSH
adjusting the settings with the remote control
If necessary, the sensor settings can be adjusted as following:
Shut off the water supply. In order to adjust the sensor with the remote control,
hold the remote control straight in front of the sensor in a distance of about 6-8"
(15-20cm). Choose the function you want to adjust by pressing once on one of the
function buttons. After pressing once on a specific function button, a quick flashing
of the LED at the front of the sensor will occur. At this stage, you can change the
setting by pressing the (+) or the (-) buttons, every push will increase or decrease
one level. After finishing the adjustment, turn the water supply back on.
DETECTION RANgE: Only if necessary, use the remote control to
adjust the sensor range as follows:
Press the RANgE button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the one level and
– to reduce it every push will increase or decrease one level.
NOTE: Once you have changed the detection range with the remote control,
this distance will be remembered by the sensor, even if the power source is
disconnected.
8
DELAY OuT TIME
TEMPORARY OFF
FuNCTION
RESET
HYgIENE FLuSH
SETTINgS aDjuSTMENT
DELAY IN TIME: If required, the delay in time can also be modified
as follows: Press the IN button. Wait until a quick flashing of the LED
in the sensor eye is perceived. Then, press + to increase the delay in
time and – to reduce it.
DELAY OuT TIME: This button allows modifying the flushing start
time after the user moves away from the product. A delay out time
close to 0 will save more water. An increased delay out time will
make the user experience more comfortable.
If required, the delay out time can be modified as follows:
Press the OuT button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay out time
and – to reduce it.
TEMPORARY OFF FuNCTION: This function is ideal to perform any
kind of activity in front of the sensor without operating the system
(for example, cleaning).
The product will remain shut for 1 minute when this button is
pressed once. To cancel this function and to return to normal opera-
tion press the On/Off button again or wait 1 minute.
RESET BuTTON: This function restores all the factory settings except
for the sensor range. If required, press the Reset button and without
releasing it, press the + button once.
SECuRITY TIME: The Security time, prevents continuous flushing
of water due to reflections or vandalism. By default, if the sensor
is covered for more than 90 seconds the water flow will shut
automatically. To resume regular operation any obstruction must be
removed.
Press the SEC button. Wait until a quick flashing of the LED of the
sensor eye is perceived. Then, press + to increase the security time
and – to reduce it.
24 HOuR HYgIENE FLuSH: This model includes a 24 hours hygiene
flush which is disabled. To activate the hygiene flush, press the clock
button. Wait until a quick flashing of the LED in the sensor eye is
perceived. Then press + to activate the hygiene flush. To disable it
again, press – to deactivate it.
COMFORT FLuSH: If your model includes a COMFORT FLuSH set-
ting, it can be activated by pressing the flush button.
When the button is pressed, one blink of the blue in the sensor eye
is perceived. The pre-programmed flush cycle will take place then.
The Comfort flush cannot be interrupted or deactivated by pressing
any button until it is over.
9