Operation And Programs - Klarstein 10030774 Manual De Instrucciones

It may happen the stirring rod remains stuck in the bread when it is turned out. In
this case, use the hook accessory as follows.
• Insert the hook in the axis of the stirring rod (A).
• Pull gently to release the stirring rod (B).
Before first Use
The appliance may emit a little smoke and a characteristic smell when you turn it on for the first time. This is
normal and will soon stop. Make sure the appliance has sufficient ventilation.
1. Please check whether all parts and accessories are complete and free of damage.
2. Clean all the parts according to the section"CLEANING AND MAINTENANCE".
3. Set the bread maker on BAKE mode and bake empty for about 10 minutes. Then let it cool down and clean
all the detached parts again.
4. Dry all parts thoroughly and assemble them, the appliance is ready for using.
Operation Instruction on Soft bread
1. Take out bread barrel from the inside of container and put stirring rod into barrel. Then place the half-round
hole of stirring rod into the right position at the revolving axle.
2. Add the appropriate amount of water, egg and flour into barrel, and finally add yeast powder. Insure yeast
powder to be added above flour and don't mix yeast powder with water, sugar and salt, otherwise the acti-
vation of yeast will be weaken or can't workable.
21

Operation and Programs

1 Yeast Powder
2 Flour or other Stuff
3 Mixture of Water, Oil, Sugar and Salt