Rollei 28031 Manual Del Usuario página 28

Modes
28
Multi mode
Parameter setting for groups
1) Press the mode button repeatedly to select
the transmitter mode as multi mode (as
shown in the picture) . Under this mode the
parameters of each group are the same .
2) If you have chosen the multi mode press the left and right button to adjust the
flash power . The flash output can be set from 1/4 to 1/128 (in total 6 levels) .
3) Setting the frequency
Press the ok button repeatedly until the frequency number is highlighted .
Press the left and right buttons to change the value from 1 – 199 Hz .
4) Number of flashes
Press the OK button repeatedly until the number of flashes is highlighted .
Press the left and right button to change the value from 1 to 40 .
Flash power & Flash times connection table
Flash power
Flash times
ENGLISH
1/128 1/64
1–40 1–20
1/32 1/16
1–12 1–8
1/8 1/4
1–4 1–2