Initial Operation - Bosch 1 270 020 500 Manual De Instrucciones

OBJ_BUCH-1392-001.book Page 12 Monday, January 17, 2011 2:51 PM
12 | English
Inserting and Removing the Battery
(see figures A–B)
Always switch the battery off when insert-
ing or removing it from the holder. When
the battery is inserted yet empty, please
also observe the drive HMI indication. Oth-
erwise, the battery can become damaged.
In order for the battery to be inserted, the key 5
must be inserted into the lock 6 and the lock
must be unlocked.
To insert the standard battery 8, place it via the
contacts onto the bottom holder 9 on the eBike.
Pivot it into the upper holder 7 so that it en-
gages into the holder.
To insert the rear rack battery 2, slide it for-
wards with the contacts facing ahead until it
engages in holder 1 on the rear rack.
Check if the battery is tightly seated. Always
lock the battery with lock 6, as otherwise the
lock can open and the battery can fall out of the
holder.
After locking, always remove the key 5 from the
lock 6. This prevents the key from falling out and
the battery from being removed from unauthor-
ised persons when the eBike is parked.
To remove the standard battery 8, switch it off
and unlock the lock with the key 5. Pivot the bat-
tery out of the upper holder 7 and pull it by the
carrying strap 10 out of the bottom holder 9.
To remove the rear rack battery 2, switch it off
and unlock the lock with the key 5. Pull the bat-
tery out of the holder 1.
0 275 007 40X | (17.1.11)
Operation

Initial Operation

Use only original Bosch batteries approved
for your eBike by the manufacturer. Using
other batteries can lead to injuries and pose a
fire hazard. When using other batteries, Bosch
shall not assume any liability and warranty.
Switching On and Off
Before switching on the battery, check that the
lock 6 is locked.
Note: When switching on the battery, the pedals
of the eBike may not be subject to load, as oth-
erwise the output capacity of the drive will be
limited.
To switch on the battery, press the On/Off but-
ton 4. The LEDs of indicator 3 light up and at the
same time indicate the charge condition.
Note: When the battery capacity is below 5 %,
none of the LEDs of charge-control indicator 3
will light up. Only the drive HMI will indicate if
the battery is switched on.
Switching on the battery is one of the require-
ments for starting up the eBike drive. Read and
observe the operating instructions of the drive
unit and the drive HMI.
To switch off the battery, press the On/Off but-
ton 4 again. The LEDs of indicator 3 go out. This
also switches off the eBike drive.
When no power output of the drive is requested
for approx. 10 minutes, (e.g., because the eBike
is parked), the battery automatically switches
off to save energy.
The battery is protected against deep discharg-
ing, overcharging, overheating and short-circuit-
ing through the "Electronic Cell Protection
(ECP)". In case of hazardous situations, a pro-
tective circuit automatically switches off the
battery.
Bosch ebike Systems