Pairing A 4-Key Remote Control With 4, 1-Relay Receivers; Description Of Advanced Training - Adeunis RF ARF 18 Instrucciones Para El Uso

2.6.2 Pairing a 4-key remote control with 4, 1-relay receivers

• Key 1 on the remote control to Rx1
On receiver 1, configure the switches as shown below.
SW1
ON
Press key 1 on the remote control
Then select SW5 OFF
Switch SW1 and SW2 to OFF if monostable mode is required. Leave switch 2 on ON if bistable mode is required.
• Key 2 on the remote control to RX2
On receiver 2, configure the switches as shown below.
SW1
ON
Press key 2 on the remote control
Select SW5 OFF
Switch SW1 and SW2 to OFF if monostable mode is required. Leave switch 2 on ON if bistable mode is required.
• Key 3 on the remote control to RX3
On receiver 2, configure the switches as shown below.
SW1
ON
Press key 3 on the remote control
Select SW5 OFF
Switch SW1 and SW2 to OFF if monostable mode is required. Leave switch 2 on ON if bistable mode is required.
• Key 4 on the remote control to RX4
On receiver 2, configure the switches as shown below.
SW1
ON
Press key 4 on the remote control
Select SW5 OFF
Switch SW1 and SW2 to OFF if monostable mode is required. Leave switch 2 on ON if bistable mode is required.
2.7.

Description of advanced training

Advanced training is limited to keys 1 to 4 (it is only available for keys 1 to 4 on a 24 key remote control).
The following associations can be made:
• Any key on the remote control can control any output on the receiver.
• One or more remote controls can control the same outputs.
• Any remote control key can control from 1 to 4 outputs on the receiver.
Gamme ARF18 UG V1.6
SW2 SW3
ON OFF
SW2 SW3
ON OFF
SW2 SW3
ON OFF
SW2 SW3
ON OFF
SW4 SW5
OFF ON
SW4 SW5
OFF ON
SW4 SW5
OFF ON
SW4 SW5
OFF ON
47