Installing & Removing Battery Pack - Klein Tools BAT20-7T Serie Manual De Instrucciones

ENGLISH
WARNING: SHOCK HAZARD. DO NOT allow any liquid to get inside the charger. Electric shock may result.
WARNING: BURN HAZARD. DO NOT submerge the battery pack in any liquid or allow any liquid to enter the
battery pack. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
NOTE: For best results, make sure your battery pack is fully charged.
• To install the battery pack
it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage.
• To remove the battery pack from the tool, press the release button
tool handle. Insert it into the charger as described in the charger section of this manual.
NOTE: After removing the battery pack, squeeze the trigger for three seconds to dissipate any electric charge that
may still be in the tool.
FUEL GAUGE BATTERY PACKS
Some DeWALT battery packs include a fuel gauge which consists of three green LED lights that indicate the level of
charge remaining in the battery pack. To actuate the fuel gauge, press and hold the fuel gauge button. A combination
of the three green LED lights will illuminate, designating the level of charge left. When the level of charge in the
battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the approximate charge left on the battery pack, according to
the indicators shown here. It does not indicate tool functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please call 1-800-4-DeWALT (1-800-433-9258) or visit
www.dewalt.com.
For more information regarding fuel gauge battery packs, please call 1-800-4-DeWALT (1-800-433-9258) or visit
www.dewalt.com.
10
BATTERY CHARGING INSTRUCTIONS
INSTALLING & REMOVING BATTERY PACK
into the tool, align the battery pack with the rails inside the tool's handle and slide
4
10
10
and firmly pull the battery pack out of the
5
75 – 100% charged
51 – 74% charged
<50% charged
Pack needs to be charged
9
8