Installing & Removing Battery Pack - Klein Tools BAT20-12T165 Serie Manual De Instrucciones

ENGLISH
DIE AND CONNECTOR SELECTION
Klein Tools 12 Ton Crimp Tool is compatible with standard U-style dies. Please refer to connector and die
manufacturers' charts for appropriate sizing and crimp quantity.
Inspect the tool before and after every use. DO NOT use this tool if it is damaged in any way.
• Personal injury can be caused by operating poorly maintained tools. Check for loose parts before using.
• Ensure the fitting is not over-specification. You may damage the tool if you do not follow the operating
instructions. Use the die specified by the connector manufacturer for your specific application.
• Remove battery pack while servicing, replacing dies, or storing the tool.
• Do not use the tool if there are any abnormalities or damage to any of its components
• Suggested working temperatures: 14°F to 104°F (-10°C to 40°C). Check hydraulic fluid specifications.
• Hydraulic fluid temperatures over 149°F (65°C) might soften packings and seals and cause fluid leaks.
• Inform Klein Tools authorized distributors or contact Klein Tools in case of any abnormalities or malfunctions of
the product.
WARNING: Never operate the tool without the dies or a connector in place.
WARNING: To avoid injury keep hands away from the tool head and workpiece during operation.
WARNING: To reduce the risk of serious personal injury, activate the trigger lock button and disconnect battery
pack before making any adjustments or removing/installing attachments or accessories. An accidental start-up can
cause injury.
INSTALLING & REMOVING BATTERY PACK
NOTE: For best results, make sure your battery pack is fully charged.
• To install the battery pack
inside the tool's handle and slide it into the handle until the battery pack is
firmly seated in the tool and ensure that it does not disengage.
• To remove the battery pack from the tool, press
the release button
7
pack out of the tool handle. Insert it into the
charger as described in the charger section
of this manual.
NOTE: After removing the battery pack, squeeze
the trigger for three seconds to dissipate any
electric charge that may still be in the tool.
FUEL GAUGE BATTERY PACKS
Some DeWALT battery packs include a fuel gauge which consists of three green LED lights that indicate the level of
charge remaining in the battery pack. To actuate the fuel gauge, press and hold the fuel gauge button. A combination
of the three green LED lights will illuminate, designating the level of charge left. When the level of charge in the
battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an
indication of the approximate charge
left on the battery pack, according to
the indicators shown here. It does not
indicate tool functionality and is
subject to variation based on product
components, temperature and
end-user application.
For more information regarding fuel gauge battery packs, please call 1-800-4-DeWALT (1-800-433-9258) or visit
www.dewalt.com.
10
OPERATING INSTRUCTIONS
into the tool, align the battery pack with the rails
6
and firmly pull the battery
8
7
6
75 – 100% charged
51 – 74% charged
<50% charged
Pack needs to be charged
8