Loading Slides - oneConcept 979GY Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Hold up the slide toward the light. Face the trademark side of the slide away from you.
Look through the slide and it should appear normally (not a mirror image).
Now turn the slide so the image is upside down while looking at the same side.
Open the slide holder at the marked spot on the top. With the slide holder open, place the
slide into recessed area in the holder- the slide should fi t perfectly.
Note: Handle slides with care. Any dust scratches or fi ngerprints will show up on your sa-
ved images. If possible use cotton gloves when handling slides. It is recommended to use
compressed air to remove any dust on the slides. This is not included with the fi lm & photo
scanner but can be purchased from an offi ce supply or electronics retailer.
Close the slide holder and press the edges so that it locks in place.
Hold it in the position as shown in the fi lm & photo scanner. Insert the Slide Holder into the
slot on the right side of the fi lm & photo scanner as shown.
20
Scan Preparations

Loading Slides

Publicidad

Tabla de contenido
loading

Tabla de contenido