Loading Negatives - oneConcept 979GY Manual De Instrucciones

• Hold up the negative toward the light. As you look through the negative you should be able
to read the small negative numbers normally (not a mirror image).
• Now turn the negative so the image is upside down while looking at the same side.
• Open the negative holder at the marked spot on the top. With the negative holder open,
place the negative into holder so the notches line up with the notches on the holder.
Note: Handle negatives with care. Any dust, scratches or fingerprints will show up on your
saved images. If possible use cotton gloves when handling negatives. It is recommended
to use compressed air to remove any dust on the negatives. This is not included with the
film & photo scanner but can be purchased from an office supply or electronics retailer.
• Close the negative holder and press the edges so that it locks in place
• Hold it in the position as shown in the film & photo scanner. Insert the negative holder into
the slot on the right side of the film & photo scanner as shown.
Scan Preparations

Loading Negatives

21