Manuales relacionados para SANUS VuePoint F107c
Resumen de contenidos para SANUS VuePoint F107c
- Página 1 F107c INSTRUCTION MANUAL We’ll Make It Stress-Free If you have any questions along the way, just give us a call. 1-888-333-9952. We’re ready to help! Scan for easy install video san.us/247...
-
Página 2: Before You Begin
IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE Before You Begin Please check the following items: Your TV and any accessories you plan to use do not exceed the specifi ed weight limit. The hole pattern on the back of your TV is compatible with the hole pattern of the TV bracket(s). -
Página 3: Weight Limit
Weight Limit Tools Needed 35 lb (15.8 kg) DO NOT EXCEED! (includes TV and any accessories) 13 mm 5.5 mm (1/2 in.) (7/32 in.) 10 mm (3/8 in. - Página 4 Dimensions [mm] 7.87 200.0 3.94 100.0 2.95 75.0 12° 20° 2.95 6.87 174.6 75.0 8.87 225.4 3.94 7.87 4.75 100.0 200.0 120.7 7.18 182.4 2.56 65.0 4.70 119.3 OFFSET 8.80 223.6...
- Página 5 Supplied Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer;...
- Página 6 Parts and Hardware for STEP 2 Washers Extender Brackets* TV Screws M4 x 12mm M4 x 35mm M4/M5 M5 x 12mm M5 x 35mm Spacers Extender Bracket Nuts* M6 x 12mm M6 x 35mm *Only needed for TVs with (7 7⁄8 x 7 7⁄8 in.) 200x200 mm hole patterns...
- Página 7 IMPORTANT: When choosing a location for your TV on the wall, please keep in Additional Hardware mind that the TV will shift 199.3 mm (4.7 in.) from the EXTENDED to the HOME positions. Allen Key 7/32 in. HOME 182.4 mm (7.18 in.) EXTENDED 119.3 mm...
- Página 8 STEP 1 Attach Wall Plate to Wall (Wood Stud ONLY!) Locate your stud(s). Verify the center of the stud using an awl, a thin nail, or an edge to edge stud finder. CAUTION: Avoid potential personal injuries and property damage! ●...
- Página 9 STEP 1 Drill pilot holes. IMPORTANT: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.), using a 5.5 mm (7/32 in.) diameter drill bit. Tighten the lag bolts only until they are pulled firmly against the wall plate CAUTION: Improper use could reduce the holding power of the lag bolt.
- Página 10 STEP 2 Select TV Hardware and Attach Interface Bracket(s) to TV Hand thread screws into the threaded inserts on the back of your TV to determine the correct screw diameter (M4, M5, or M6). Determine what kind of TV you have and if you require extra space between the wall and the TV to accommodate cables. •...
- Página 11 STEP 2 (7 7⁄8 x 7 7⁄8 in.) install the extender brackets IMPORTANT: If the hole pattern on your TV is 200x200 mm using the nuts provided. If your TV hole pattern is less than 200x200 mm do not install the extender brackets. Skip ahead to STEP 2-A or 2-B.
- Página 12 STEP 2-A Install the top two screws but do not fully tighten. Leave a small gap so you can slide the TV bracket into place and then install the bottom two screws. Ensure that your bracket is level on the back of the TV. If you need extra space to accommodate cables, recesses, or protrusions;...
- Página 13 STEP 2-A NOTE: If the hole pattern on your NOTE: If the hole pattern on your TV is 200x200 mm, TV is 75x75mm the washers are not used. Install all four screws at the install all four screws at the same time.
- Página 14 STEP 2-B Install the top two screws but do not fully tighten. Leave a small gap so you can slide the TV bracket into place and then install the bottom two screws. Ensure that your bracket is level on the back of the TV. Standard confi gurations are shown. For special applications, or if you are unsure about your hardware selection, contact Customer Service.
- Página 15 STEP 2-B NOTE: If the hole pattern on your NOTE: If the hole pattern TV is 75x75mm the washers are not on your TV is 200x200mm, used. Install all four screws at the install all four screws at the same time. same time.
- Página 16 STEP 3 Manage Cables NOTE: Leave enough slack in the cables to allow the TV to move freely.
- Página 18 Troubleshooting ADJUSTING TENSIONS REMOVING THE TV If you need to remove your TV, SWIVEL EXTEND/RETRACT disconnect all cables and then reverse the procedures in STEP 2A /2B. 7/32 in. TILT Loosen the knob on the TV bracket to adjust the tilt of your TV. Tighten the knob when your TV is set to the desired tilt.
-
Página 20: Antes De Comenzar
ESPAÑOL INSTRUCCIONES DE SEGURIDAD IMPORTANTES. CONSÉRVELAS. LEA TODO EL MANUAL ANTES DE UTILIZAR ESTE PRODUCTO. Antes de comenzar Cerciórese de: que su televisor y los accesorios que planifi ca usar no excedan el límite de peso especifi cado; que el patrón de orifi cios de la parte trasera de su televisor sea compatible con el patrón de orifi cios de la(s) placa(s) de sujeción para el televisor;... -
Página 21: Piezas Y Elementos De Sujeción Suministrados
ESPAÑOL Piezas y elementos de sujeción suministrados ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor;... -
Página 22: Seleccionar Los Elementos De Sujeción Y Colocar El Soporte De Acoplamiento Al Televisor
ESPAÑOL PASO 2 Seleccionar los elementos de sujeción y colocar el soporte de acoplamiento al televisor Enrosque manualmente los tornillos en los encastres roscados de la parte posterior del televisor a fi n de determinar el diámetro correcto de los tornillos (M4, M5 o M6). - Página 23 ESPAÑOL ¡ELEMENTO PESADO! NOTA: Si el patrón de orifi cios de NOTA: Si el patrón de orifi cios de su televisor es de 200 x 200 mm, Es posible que necesite su televisor es de 75 x 75 mm, no instale los cuatro tornillos al se usan las arandelas.
- Página 24 Thank you for choosing Sanus VuePoint! Please take a moment to let us know how we did: Call us: 888-333-9952 Email us: info@sanus.com Leave a review: vuepoint.sanus.com UK: 0800 056 2853 Milestone AV Technologies and its affi liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations.