Controls; Keyswitch; Volt Power Outlet - Craftsman professional 127.28875 Manual Del Operador

CONTROLS
KEYSWITCH (K)
- The keyswitch has three
positions: OFF, RUN, and START. Insert the key
and turn it clockwise to move the switch from OFF to
RUN. Turn it further to START and hold to engage
the starter. Release the key and the switch will return
to RUN from START. Turn the key counterclockwise
to OFF to stop the engine.
THROTTLE (T) - Move the throttle lever forward to
increase engine speed until the maximum governed
engine RPM is reached. Move the lever rearward to
decrease engine speed until the engine reaches its
idle speed,
CHOKE (C)
For Kawasaki and Briggs and Stratton Engines, pull
the choke control out to set the choke ON. Push it in
to set the choke OFF.
POWER TAKE OFF (PTO) SWITCH (P)-
The operator must be in the seat when engaging the
PTO or the engine will kill. Pulling the PTO switch
out engages (turns on) the PTO and starts the blades
or other attachment. Pushing the PTO switch in
disengages (turns off) the PTO and stops the blades
or other attachment.
NOTE: The PTO switch does not control
attachments powered by a separate engine.
Disengage the PTO whenever you stop or leave
the operator's position
Shut off engine with the key and remove the
spark plug wires before making adjustments or
unplugging a clogged mower.
Do not engage the PTO until ready to start
mowing,
12 VOLT POWER OUTLET (X)
A 12 volt power outlet is provided to operate 12 volt
personal accessories.
14
At operator's right side
Below seat