Etroubleshooting - Remington I Light Manual De Instrucciones

ENGLISH
CLEANING YOUR i-LIGHT DEVICE
C
F CAUTION: Before cleaning your i-LIGHT, make sure that the device is switched OFF and the power cord
is disconnected from the device.
• Regular cleaning helps to ensure optimal results and a long life for the i-LIGHT device.
• To clean the Flash Window, use only the lint-free cloth included with your i-LIGHT device. Take care not
to scratch or chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit.
• For stubborn stains on the flash window, dampen a cotton swab with surgical spirit or rubbing alcohol,
apply to the flash window and clean gently with the lint-free cloth provided.
Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
F WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the filter
glass or the metallic surface inside the Treatment Head.
F CAUTION: The i-LIGHT is a high voltage device. Never immerse in water. Never clean the unit or any of
its parts under a tap or in a dishwasher.
, Storage
• Switch off the unit, unplug and allow to cool for 10 minutes before storage.
• Store the unit in a dry place at a temperature between 15º C and 35º C
TROUBLESHOOTING
E
• Always read these instructions fully before using i-LIGHT
• Refer to this troubleshooting guide if you experience any problems with i-LIGHT, as this section
addresses the most common problems you could encounter with i-LIGHT. If you have followed the
instructions in this section and continue to experience problems, please contact the Remington®
Service Centre for further assistance.
, The power switch is ON, but the unit is not working.
• Make sure the unit is plugged into a working electrical outlet.
• Try switching to a different outlet.
, The unit appears to have cracks or is broken.
• Do not use if the unit is damaged. If you have concerns about using the unit, discontinue use and
contact the Remington® Service Centre for further assistance.
, I have switched the unit ON, but I cannot increase or decrease the energy level.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
, The Bulb Status Indicator Light turns green but the unit does not flash when the button is pressed.
• Make sure the Skin Contact Sensor is in full contact with the skin.
• Try resetting the unit by turning it off and waiting several seconds before turning it back on.
, There is a strange smell.
• Be sure the area is completely shaved before treatment.
14