Cleaning The Cabinet - Tripp-Lite SRCOOL2KWM Manual Del Propietário

Operation
Changing Degree Units
The unit can display temperatures in both Celsius and Fahrenheit. The default setting for the
SRCOOL2KWM is Fahrenheit.
To toggle between temperature modes, put the unit in standby mode. The air conditioner is in
standby mode when it is plugged into live AC power, but powered off. Then, press and hold the
"FUNCTION" key for 10 seconds. After 10 seconds, the display will flash the temperature in the
new degree units. Power the unit back on to resume operation.
Alarm
If the internal water tank becomes full, the unit will display the "E4" error code on its screen. To
resume normal function, turn the unit off, remove the drainage plug and drain the excess water
from the unit. Replace the plug and turn the unit on to begin cooling.
One possible cause of the "E4" error is an excessively humid operating environment. If the error
occurs regularly, you should check the humidity level of the operating environment. You may
need to add an external drain.
Maintenance
Periodic maintenance extends the unit's lifespan and permits maximum operating efficiency.
Cleaning the Air Filters
It is important to keep the air filters clean
and free of dust. When the filters are dirty
or clogged with dust, it decreases cooling
efficiency and can threaten air quality.
Tripp Lite recommends cleaning the filters at
least once every two weeks.
Before cleaning the filters, turn
the unit off and unplug it!
There is a risk of electric shock
while the unit is plugged in.
1. Turn the unit off and unplug it.
2. Remove the air filters.
3. Wash the filters with warm water and
a neutral detergent. Do not use harsh
detergents or chemicals. Allow the filters to
air dry completely after washing.
Note: Do not use water hotter than 104° F
(40° C) to clean the filters.
4. Replace the air filters.
5. Plug the unit in and resume normal
operation.

Cleaning the Cabinet

Before cleaning the cabinet, turn the unit off and unplug it!
There is a risk of electric shock while the unit is plugged in.
1. Turn the unit off and unplug it.
2. Wipe the unit with a dry, non-abrasive cloth. Do not use gasoline, benzene, thinners or other harsh chemicals that may damage the surface.
Do not pour water directly over the unit or into the working parts. This causes a risk of electrical shock and deterioration of electrical
components and wiring insulation.
3. In extreme cases, wipe the unit with a damp cloth to remove residue.
Moving the SRCOOL2KWM
1. Turn the unit off and unplug it.
2. Remove the drainage plug and drain any excess water from the unit.
3. Replace the plug.
4. Move the unit to the desired location.
10