Block Diagram Of The Device; Installation; Preparation - Aprimatic A40M-2 Professional Instrucciones Para La Instalación

Device with an Aprimatic microprocessor designed to operate 2 motors with a maximum
absorbed power of 250 W.

1.1 BLOCK DIAGRAM OF THE DEVICE

L1 Start LED
Always OFF - it comes ON following the start command
L2 Stop LED
Always ON - it goes OFF following the stop command
L3 Photocell/safety LED
Always ON - it goes OFF following the safety signal
L4 Motor 1 relay LED
L5 Direction relay
L6 Motor 2 relay LED
L7 Electric lock relay LED
L9 Pilot light and test LED
J1 Signal terminal board (inputs)
J2 Power supply terminal board (outputs)
J3 Decoding board/plug-in radio receiver connector
J4-J5 Optional board connector
T1 Transformer
F1 Motor power supply 5A fuse
F2 Electric lock 2A fuse
F3 24VDC power supply 2A fuse
K1 Motor 1 relay
K2 Motor 2 relay
K3 Direction relay
K4 Electric lock relay
SW1 Time setting dip-switch
SW2 Functioning mode dip-switch
U1 Microprocessor
C14-C15 Capacitors 15µF 250V
CAUTION - The product must only be installed by qualified servicing and/or installation
personnel.
CAUTION - The electrical system must comply with the current regulations in the
country where the product is installed.

2.1 PREPARATION

Before installing the device, prepare the tools required for securing it to the wall and to
make the electrical connections. The following are also required:
Closing
Opening
Blue (common lead)
Closing
M1 - To control a single leaf
Opening
Blue (common lead)
APR02001.EPS
M2 - For leaf opening delay (standard)
max 250 W
using the optional RA/AS
Flashing light
board.
Enabled for leaf closing
delay (standard) max 250 W