Preventing Radio Interference; Electrical Connection - Caso Master P1 Manual De Instrucciones

13.5.2

Preventing Radio interference

13.6 Electrical connection

caso Master P1
The appliance can cause interference to radios, televisions or
similar devices. Interference can be removed or reduced using
the following measures:
x Place the radio, television etc. as far away from the appliance
as possible.
x Connect the appliance to a different socket, so that different
electric circuits are being used for the appliance and the
receiver experiencing interference.
x Use a correctly installed aerial for the receiver in order to
ensure good reception.
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
x Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
x The electrical outlet must be protected by a 16A safety cut-out
switch.
x The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
x Make sure that the power cable is undamaged and has not been
installed under the oven or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the device
is connected to a properly installed protective conductor system.
Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that
are caused by a missing or damaged protective conductor.
47